The development of sheet metal deburring machines

Sheet metal deburring machine, the development history is approximate25 years. Initially, the male rotation of Dupont silk straight wire was used because the straight wire was too thin, the revolution rotation would explode too quickly, the silk would be hard when it was thick, and the grinding surface would be too hard, and the consumables were too large, so it was eliminated 20 years ago.

Later, it was popular to use yarn blocks to pull left and right, sand blocks are composed of sandpaper and nylon, a belt full of sand blocks on the left and right, with sand blocks to polish the product left and right, and even the bottom can make two belts with sand blocks, which has become the so-called double-sided deburring machine and wire drawing, because the sand block is not flexible enough, so most of it is also ground on the surface, and the speed is not high enough, resulting in a very high consumption of consumables, and only the left and right grinding are relatively uneven and eliminated.

Later, a company in Mai used a roller brush to turn into a new method in this industry, calledUniversal roller brush to remove burrsBecause the high speed just explodes into inertia, the male rotation is also evenly edged, hanging on the edge of the product, that is, the position of the burr, which has become the mainstream of this industry to this day, and it is also the method accepted by everyone.

So Germany and Japan began to produce this kind of equipment, probably in15 years ago.

This equipment is made of gearbox and gearbox, resulting in the overall service life of one to three years because there is too much angular force transmission. And the cost is very high, all of them1 million up. China began to follow suit, with its own simple gear transmission, 6 to 100,000. A better brand is four or five hundred thousand, but also because of the corner and high speed of the gearbox, wear resistance has become a big problem. The cost of use is high. Devices from 5 to 100,000 can basically be tried but not used. 1.3 million equipment will exceed the cost of this equipment in about 7 years. So it limits the development of this industry.

Because this is a new industry, creation is particularly important. Zhongchuang, our creation is to solve all the previous problems, there are no gears, no oil, no belts or timing belts inside the nose. Since the development of a special grinding and polishing spindle, heat dissipation, dustproof, high speed, anti-shake, it has pushed this industry to a new height.Service life30 years。 And solve the function of the intelligent speed spindle that is not easy to use because the wheel is small and the line speed cannot reach the function of the intelligent speed spindle. This spindle will automatically increase the speed to maintain the line speed because the use of the wheel becomes smaller, so that the product made of the size of the new and old wheels has the effect of consistency. It can be understood that we have given it life and taken the entire industry to a new journey.

our factory and production workshop：